Unbricking Samsung Galaxy Wonder GT-I8150 With RIFF Box

Unbricking Samsung Galaxy Wonder GT-I8150

Unbricking / Boot Repair Samsung Galaxy Wonder GT-I8150 is easy and without disassembling the phone.

Symptoms : 

• Phone's dead or black screen
• Can't charging
• Can't entering download mode or recovery mode

Causes : 

• Upgrade firmware process fault
• Rooting
• Flashing with wrong firmware
• Other software process fault

Tool & Materials :

• RIFF Jtag box
• Soldering tool
• PC

Step by step :

• Connect RIFF box to PC
• Open RIFF software, select Samsung I8150 model
• Set JTAG TCK Speed to RTCK, sample at Max
• Click interface pinout
• Open sticker / label, there's JTAG pinout
• Solder JTAG cable to phone JTAG pad / pinout, GND, NRST, TDO, RTCK, TCK, TMS, TDI and TRST pin.
• Insert battery or power suply and connect USB cable to phone, in some case, you need to hold power on button while resurrection process.
• Select JTAG Read/Write tab and click Connect & Get Id to check connection, and you will get this log below if connection is ok.

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung I8150 V1.00]

Connecting to the dead body...OK
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK

Detected dead body ID: 0x27B360E1

•  Select Resurrection tab, Click Resurrection and Instruction window will appear, click "i have read this manual..........., and close window.
• Resurrection processing and wait untill done and you will get this log below if resurrection is done

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung I8150 V1.00]

Connecting to the dead body...OK
Detected dead body ID: 0x27B360E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0000 (SEM04G, 0x0000EC000000 Bytes = 3.69 GB)

Flashing the dead body...OK
Resurrection complete!

•  De-solder JTAG wires

Now phone is in bootable conditions, and still need flashing Stock ROM via Odin.  To put into download mode, press & hold Volume Down (-)  +  Home button and then power on the phone, press volume up to confirm

Posted in: RIFF JTAG, Samsung JTAG Log